Name: 7/8"
Brand: binder
SKU: 09 2473 100 03

Illustration 09 2473 100 03 - 7/8 — Illustration

Pin assignment plans 09 2473 100 03 - 7/8 — Pin assignment plans

Scale drawing 09 2473 100 03 - 7/8 — Scale drawing

Contact arrangement (Plug-in side) 09 2473 100 03 - 7/8 — Contact arrangement (Plug-in side)

This female connector with screw locking and a pin count of 3 is according to its protection class IP68 Dustproof and complete protection against contact. Protection against permanent submersion. Unless otherwise specified, protection up to 1 meter water depth. It can be used in areas with a pollution degree of 3. In places where contamination can occur that is conductive or can become conductive through condensation. With temperatures ranges of -30 °C/85 °C is this unshielded 7/8" Buchse designed for both severe cold and severe heat and has the VDE approval. Due to the qualified rated voltage of 300 V and the rated current of 10,0 A it is perfectly tuned for its field of application.

Moreless

Part no.	09 2473 100 03
Connector design	Twin distributor
Version	T-Distributors
Connector locking system	screw
Termination	solder
Degree of protection	IP68
Temperature range from/to	-30 °C / 85 °C
Mechanical operation	> 100 Mating cycles
Additional information	Threaded nut die-cast
Weight (g)	68.28
Customs tariff number	85369010
Country of Origin	DE

Moreless

Rated voltage	300 V
Rated impulse voltage	4000 V
Rated current	10.0 A
Pollution degree	3
Overvoltage category	II
Insulating material group	I
EMC compliance	unshielded

Moreless

Housing material	Macromelt
Contact body material	PUR
Contact material	CuZn (brass)
Contact plating	Au (gold)
REACH SVHC	CAS 7439-92-1 (Lead)
SCIP number	25b5dd04-b40d-40bb-9099-cd876478f3aa

Moreless

Approvals	VDE

Moreless

eCl@ss 11.1	27-44-01-09
ETIM 9.0	EC003569

Moreless

Low Voltage Directive	2014/35/EU (EN 60204-1:2018;EN 60529:1991)

Report error on this page

General Disclaim Notice

The connector must not be plugged or unplugged under load. Non-observance and improper use can result in personal injury.
The connectors have been developed for applications in plant engineering, control and electrical equipment construction. The user is responsible for checking whether the connectors can also be used in other areas of application.
Connectors which are used in circuits with voltages dangerous to the touch may only be installed and used by, or under the supervision of, persons with electrical engineering training, taking into account the applicable regulations and standards.
Plug connectors with enclosure protection IP67 and IP68 are not suitable for use under water. When used outdoors, the plug connectors must be protected separately against corrosion. For further information on the IP protection classes, please refer to the "Technical Information" download centre.
To lock the cable connector to the device connector, we recommend tightening the threaded ring to 1.5 Nm. A suitable torque wrench is available as an accessory (order no. 07 0082 000).

Downloads

all (PDF)

Data sheet

Data sheet 09 2473 100 03

PDF

download