Part no.: 09 2447 180 03
7/8" Male panel mount connector, Contacts: 2+PE, unshielded, THT, IP68, UL, VDE, front fastened
7/8", series 820, Automation Technology - Voltage and Power Supply
This male panel mount connector with screw locking and a pin count of 2+PE is according to its protection class IP68 Dustproof and complete protection against contact. Protection against permanent submersion. Unless otherwise specified, protection up to 1 meter water depth. It can be used in areas with a pollution degree of 3. In places where contamination can occur that is conductive or can become conductive through condensation. With temperatures ranges of -25 °C/85 °C is this unshielded 7/8" male panel mount connector designed for both severe cold and severe heat and has the UL, VDE approval. Due to the qualified rated voltage of 300 V (600 V UL) and the rated current of 10,0 A it is perfectly tuned for its field of application.
General features
MorelessPart no. | 09 2447 180 03 |
Connector design | Male panel mount connector |
Version | Connector pin straight |
Connector locking system | screw |
Termination | THT |
Degree of protection | IP68 |
Cross-sectional area | 0.75 mm² / AWG 18 |
Temperature range from/to | -25 °C / 85 °C |
Mechanical operation | > 100 Mating cycles |
Weight (g) | 45.00 |
Customs tariff number | 85369010 |
Country of Origin | DE |
Electrical parameters
MorelessRated voltage | 300 V (600 V UL) |
Rated impulse voltage | 4000 V |
Rated current | 10.0 A |
Pollution degree | 3 |
Overvoltage category | III |
Insulating material group | I |
EMC compliance | unshielded |
Material
MorelessContact body material | PUR |
Contact material | CuZn (brass) |
Contact plating | Au (gold) |
REACH SVHC |
CAS 7439-92-1 (Lead) |
SCIP number | 1ff9304b-b0a0-4382-a54b-d6a43a71b0a1 |
Authorization/approvals
MorelessApprovals | UL, VDE |
Classifications
MorelesseCl@ss 11.1 | 27-44-01-09 |
ETIM 9.0 | EC003569 |
General Disclaim Notice
- The connector must not be plugged or unplugged under load. Non-observance and improper use can result in personal injury.
- The connectors have been developed for applications in plant engineering, control and electrical equipment construction. The user is responsible for checking whether the connectors can also be used in other areas of application.
- Connectors which are used in circuits with voltages dangerous to the touch may only be installed and used by, or under the supervision of, persons with electrical engineering training, taking into account the applicable regulations and standards.
- The user must take suitable safety precautions to ensure that the connector cannot be accidentally disconnected.
- Plug connectors with enclosure protection IP67 and IP68 are not suitable for use under water. When used outdoors, the plug connectors must be protected separately against corrosion. For further information on the IP protection classes, please refer to the "Technical Information" download centre.
- The plug connector is not suitable for mains voltages Please observe the pollution degree and the overvoltage category. For further information, please refer to the download center "Technical Information".
- To lock the cable connector to the device connector, we recommend tightening the threaded ring to 1.5 Nm. A suitable torque wrench is available as an accessory (order no. 07 0082 000).